$7 Minimum Shipping — USA Addresses $13 minimum on phone orders · Worldwide shipping — see checkout for all options · insurance automatically added to USA orders over $50
Ever crease your horizontal stab in a crash or flip on landing? I've made this mistake a time or two and the reason why we designed this part. Not a bad idea to put it on from the beginning. A great way to repair an already damaged stab section. Made from 1/64th aircraft ply. Each package contains 2 parts. Glue to the surface of your stab. Top and bottom or just one side if you like. Factory mounting holes are already pre-drilled and ready to go. The thin ply is still flexible and is designed to prevent the stab from creasing at the boom when stressed too far.
If your building a canard, this part would really be a must have as the canard is under much greater flight loads than a horizontal stab. Also not to be overlooked is anything you run the model into hits the canard first. Save yourself some troubles later on by using this part now.
Suggested method is to glue to surface(s) with a thin smear of GWS's provide glue or CA, center carefully and weigh down with a modest weight like a book against a flat surface until dry.
 "Horizontal Stab Stiffener Plates")