Connector for use on ignition engines (3W). 9 inch pigtails, 18 gauge wire. Tight fitting, vibration resistant polarized plugs. One male, one female per set.
6 inche extension includes ferrite toroid. Perfect between RX and throttle servo which is mounted up front near spark ignition system. Greatly reduces RF interference from ignition system that would otherwise wick down servo wire into your RX. Also useful for battery packs or any other items located close to ignition or any other source of unwanted RF.
Connector for use on ignition engines (3W). 9 inch pigtails, 18 gauge wire. Tight fitting, vibration resistant polarized plugs. This listing is for one male connector only. Photo is for display only.
9 inch pigtail, 18 gauge wire. Tight fitting, vibration resistant polarized plugs. This listing is for one female connector only. Photo is for display only.
6 inch extension includes ferrite toroid. Perfect between RX and throttle servo which is mounted up front near spark ignition system. Greatly reduces RF interference from ignition system that would otherwise wick down servo wire into your RX. Also useful for battery packs or any other items located close to ignition or any other source of unwanted RF.
SKU Number: RRCRFNSUP6JR
Radio Ignition Wire
Reliable connections between radio gear, ignition, and onboard wiring keep a model flying safely, and this category collects the plugs, pigtails, and leads used to build and extend those circuits. The parts here center on the AMP connector system along with noise-control hardware for cleaner radio performance.
AMP Connectors and Pigtails
The Amp Pigtail Set and the individual AMP 2-Pole Male and Female Pigtails give you pre-wired ends for making up custom leads. Matching Male and Female AMP Pin Kits supply the loose pins and shells for assembling connectors to your own length and layout. Making up your own leads lets you route wiring cleanly around tanks, mounts, and hatches.
Noise Suppression
Electrical noise can interfere with receiver reception, and the RF Noise Suppression Extension in the Futaba J pattern adds filtering into a servo or signal run to help keep control channels clean.
Browse the connectors and leads below to build the wiring your setup calls for.
 "Amp Pigtail Set")
 "RF Noise Suppression Extension Futaba J")
 "AMP 2-Pole Male Pigtail Only")
 "AMP 2-Pole Female Pigtail Only")
 "Male AMP Pin Kit")
 "Female AMP Pin Kit")
 "RF Noise Suppression Extension JR")
