Digital Power Regulator Switch and Low-voltage Alarm
A digital switch and linear voltage regulator in one that simplifies wiring in your craft. Rated for 10 amps constant, 20 amps burst (Max 8 seconds). Perfect for use with 2S LIPO packs. Simple opperation, hold button 1 second to turn on, hold button 1 second to turn off.
Low voltage warning beeps start when input voltage falls to 7V, increased warnings at 6.6v. Warning beeps and flash become rapid at 6V. So efficient, when off, it would take 886 days to consume 1000mah out of your pack.
Specifications: Regulated Voltage: 6.11v (less than fully charged 6V NiCad or NiMH pack which is about 7.5v) Max Input Voltage: 9V Current used at idle when on: 3.897mah Current with alarm sounding: 21 mah Current used when off: .047 mah (1/21276th of an amp!) Cutout Dimensions: .663" (16.9mm) x 1.8" (45.7mm) Weight: .701 oz. (19.8g)
Digital Power Regulator Switch and Low-voltage Alarm
A digital switch and linear voltage regulator in one that simplifies wiring in your craft. Rated for 10 amps constant, 20 amps burst (Max 8 seconds). Perfect for use with 2S LIPO packs. Simple opperation, hold button 1 second to turn on, hold button 1 second to turn off.
Low voltage warning beeps start when input voltage falls to 7V, increased warnings at 6.6v. Warning beeps and flash become rapid at 6V. So efficient, when off, it would take 886 days to consume 1000mah out of your pack.
Specifications: Regulated Voltage: 6.11v (less than fully charged 6V NiCad or NiMH pack which is about 7.5v) Max Input Voltage: 9V Current used at idle when on: 3.897mah Current with alarm sounding: 21 mah Current used when off: .047 mah (1/21276th of an amp!) Cutout Dimensions: .663" (16.9mm) x 1.8" (45.7mm) Weight: .701 oz. (19.8g)
SKU Number: RRCVREGSWJR
RC Switches and Switch Harnesses
The power switch is the one link between your battery and the receiver, so a solid switch harness is cheap insurance against an in-flight shutdown. This category collects switches and harnesses for turning onboard RC systems on and off.
Monitoring Switch Harnesses
Several MPI Onboard Switch Harnesses add a 3-LED voltage monitor so you can check pack condition at a glance. Versions are offered for 4.8V and 6V packs as well as 7.4 volt LiPo and Li-ion cells, with connector choices such as Futaba, JR, Spektrum, Deans, and universal.
Heavy Duty Switches
For larger current draws, Heavy Duty Switches with a built-in charge jack and indicator light let you charge without unplugging, in Futaba and JR/Hitec/Airtronics connector styles. The charge jack simplifies topping off a flight pack. Choosing a harness comes down to your battery type and the connectors already on your receiver, so matching those keeps installation simple.
Select a switch or harness to match your pack and radio below.
 "RRC V-Reg Digital Switch Futaba Type Plugs")
 "RRC V-Reg Digital Switch JR/Hitec/Spektrum Type Plugs")
