This charge adapter cord lets you charge 1, 2, 3 or 4 MCX bind and fly 1S battery packs in series. No need to fill it up, you can charge any number up to 4 in one charge session. The cord must be used with a Balance charger AND it MUST be in balance mode. Just putting it in charge mode will damage the batteries. Be sure you advance your lipo menu to BALANCE. This way you get to charge 3 battery packs at one time on one port. The balance end fits all the chargers we sell (excepting FMA Cell Pro) plugging directly into your chargers balance board port or 6S XH port. Charge input leads are standard 4mm bullets like all your normal charge cords.
This harness has 3 inputs for the Single cell connector and can be purchased just to get these pigtails to remove for your own custom charge harness if you like.
USB to 2S XH Charger Cable for 2S 7.4V Lipo & LI-Ion Batteries, Approximately 53cm/21 inches in length, USB end to XH end, 1 EACH.
INPUT: 5V ~ 0.5~2A
OUTPUT: 7.4V 1000mAh
SKU Number: RRCCGCD2SUSBXH
Charge Cords for Electric Flight
Connecting a charger to a flight pack takes the right lead, and this category collects charge cords for electric flight built around the connectors and layouts modelers actually use. The mix covers single leads, multi-port cords, and parallel setups for charging several packs at once.
Connector-Specific Leads
Ready-made cords include RRC charge cords in XT60 and XT90, each in a 30cm length, plus a Multiplex charge cord for that connector system. Matching the cord to the plug on your pack avoids adapters and loose joints.
Multi-Port and Parallel Charging
For charging more than one pack, a 7 way charge cord and an MCX 4 way cord fan out to several batteries, while the MPA-4P multi-port safe parallel module with Deans connectors handles parallel charging of compatible packs so a session's batteries can be topped up together.
Pick the cord that matches your connectors and charging routine below.