7 way cord. Includes plugs compatible with BEC, Tamiya, Traxxas, EC3, Futaba & JR RX's*, plug with cap and extra set of insulated leads so you can customize with and 8th plug. *Fits TX's with Universal and Futaba J servo ends also. Won't fit inside charge jack type switches for JR/Airtronics/Hitec where charging is through a window in the switch face. Works will all JR/Airtronics/Hitec batteries directly and switches with charge pigtails (except antique old Airtronics and antique Futaba G)
Connect 3 each 2S packs or 2 each 3S packs in series to charge as 6S assembly. To be used ONLY when charging in BALANCE MODE. The best way to charge packs that are being discharged in series. Balance harness from battery pack must be plugged into the balance connector immediately adjacent to the charge connector where your heavy wires are plugged in.
Found on larger single cell models (generally 300mah and up). Use to build your own single or multi-charge cords for single cell Bind and Fly battery packs. 22 gauge wire (heavier than normal). This is the plug found on charge cords and ESC battery inputs.
Genuine Deans Ultra plug added to one of our heavy duty silicone charge cords. 11-12" long with banana plugs for most common chargers. We use only Genuine W.S. Deans Plugs. Standard 4mm banana on charger end.
Genuine Deans Ultra plug added to one of our vinyl heavy duty charge cords. About 20-24" long with standard banana plugs for most common chargers. We use only Genuine W.S. Deans Plugs. Standard 4mm banana on charger end.
Genuine Deans 2 pin mini polarized plug added to one of our 22 gauge charge cords. About 18" long with banana plugs for most common chargers. We use only Genuine W.S. Deans Plugs.
Red BEC/JST charge cord for the most common park flier battery packs. This is the same plug used on all the S-300 and smaller GWS birds. It's the only red plug with covered pins. About 24" long. Standard 4mm banana on charger end.
This charge adapter cord lets you charge 3 MCPX connectored 1S battery packs as a 3S series pack. The cord must be used with a Balance charger AND it MUST be in balance mode. Just putting it in charge mode will damage the batteries. Be sure you advance your lipo menu to BALANCE. This way you get to charge 3 battery packs at one time on one port. The XH 3S balance connector plugs directly into your balance port or balance board. Use a Red JST charge cord to interface with the Red JST plug for the power input. Set your charger to 3S, your choice of charge rate (observe MFG reccomendations) in balance mode and your off to the races. With a 4 port charger, it's simple to get 12 battery packs charging at once.
This harness has 3 inputs for the MCPX connector and can be purchased just to get these pigtails to remove for your own custom charge harness if you like.
Kyosho Block MALE CLIP plug added to one of our heavy duty charge cords for you. About 24" long. Standard 4mm banana on charger end.
SKU Number: RRCCGCDTAMMC
Charge Cords for Electric Flight
Connecting a charger to a flight pack takes the right lead, and this category collects charge cords for electric flight built around the connectors and layouts modelers actually use. The mix covers single leads, multi-port cords, and parallel setups for charging several packs at once.
Connector-Specific Leads
Ready-made cords include RRC charge cords in XT60 and XT90, each in a 30cm length, plus a Multiplex charge cord for that connector system. Matching the cord to the plug on your pack avoids adapters and loose joints.
Multi-Port and Parallel Charging
For charging more than one pack, a 7 way charge cord and an MCX 4 way cord fan out to several batteries, while the MPA-4P multi-port safe parallel module with Deans connectors handles parallel charging of compatible packs so a session's batteries can be topped up together.
Pick the cord that matches your connectors and charging routine below.
 "7 Way Charge Cord")
 "MCX 4 way Charge Cord")
 "Multiplex Charge Cord")
 "RRC Charge Cord XT60 30cm/12\"")
 "RRC Charge Cord XT90 30cm/12\"")
 "Charge Cord Board 3x2S or 2x3S into 6S")
 "4x XT60 Charge Cord")
 "Anderson Power Pole / Sermos Charge Cord")
 "4x Anderson Power Pole / Sermos Charge Cord")
 "Bind-N-Fly Receptacle Pigtail Large Plug")
 "Deans Ultra Charge Cord Silicone 11-12\"")
 "Deans Ultra Charge Cord Heavy Duty Vinyl 20-24\"")
 "4 Way Charge Cord With Caps")
 "DEANS Mini 2 Pin Polarized on a Charge Cord")
 "EC3 Charge Cord")
 "4 Way EC3 Charge Cord")
 "EC5 Charge Cord 22ga 16-18\"")
 "4 X EC5 Charge Cord")
 "BEC / JST Charge Cord")
 "Tamiya Block Female Charge Cord")
 "Bind-N-Fly Receptacle Pigtail (Futaba Telemetry)")
 "MCPX 3 Series Charge Cord")
 "Multi Kyosho/Tamiya/Amp Charge Cord")
 "Kyosho MALE CLIP Charge Cord")
