How it works: SwitchGlo Pro simply plugs into a receiver channel, then to your glow plug. You assign a transmitter toggle switch to this SwitchGlo channel, and toggle your glow on and off, at startup or in-flight.
You can program mix SwitchGlo just as you can program mix any servo on your craft, allowing you to utilize your glow in ways you never thought possible! Low Throttle glow activation is achieved by programming your TX to activate the SwitchGlo channel at any throttle position you desire. You can further enhance your Low Throttle mix by assigning a toggle switch to activate the mix, thereby forever preventing "Hot Starts"
Know when you glow! - SwitchGlo will beep the entire time your glow plug is glowing, providing invaluable reassurance you never thought you needed! SwitchGlo helps you diagnose starting problems; a single beep from SwitchGlo signals the glow/ground loop is open, most often indicating your glow plug is spent. This feature greatly reducing your troubleshooting efforts!
Technology: SwitchGlo Pro is an intelligent and highly efficient on-board glow driver. Its state-of-the-art voltage adaptive algorithm optimizes the power transferred from your battery pack to your glow plug providing the ideal glow. Outfitted with low power components, switched-mode voltage regulation and adjustable firmware, SwitchGlo is not your conventional on-board glow system.
Other on-board glow systems use linear regulators that waste power (up to 3 times as much) and operate at dangerously high temperatures. These linear glow drivers also suffer from low glow at lower pack voltages, while SwitchGlo gives a strong and consistent glow from 4V - 9V. Combining the benefits of switch-mode voltage regulation and the smallest footprints on the market, SwitchGlo Pro is the most advanced way to glow!
This is gator clip version. Easy to cut gator off and solder on any plug connector you like. We have several options in stock. Check out "Glow & Fuel Power Everthing" sub category "Glow Plug Fittings" for a wide variety. At your Add any of them to your basket and include a note with order that you'd like it added to your SwitchGlo Pro along with wire length you'd like. We'll do the soldering no charge!
The Pushbutton plugs into SwitchGlo Pro and is mountable anywhere on your craft. You can use it as a secondary glow trigger along with your transmitter or as the sole method to trigger SwitchGlo Pro. The Pushbutton is a 15 inches in length, thin, durable, and flexible. It can be twisted, folded and stuck anywhere with double stick tape or Velcro. The pushbutton area is trimable to your specific mounting location. SKU Number: SGPROPB15
SwitchGlo Pro Push Button LED 15 Inch Extension" />
This Kit allows a "do-it-yourselfer" to build your own custom switch and LED accessory for SwitchGlo Pro. The Push-Button is a secondary glow trigger while on the ground and the LED is for visual confirmation that your glow-plug is infact glowing. Highly recommended for the Scale-Modeler who wants an On-Board Glow Indicator while in flight, but also keep the most realistic look without having unnecessary cut-outs in the body of the aircraft. Now you have the freedom to mount an extra LED and Pushbutton anywhere on your craft. SKU Number: SGPROPBLED
SwitchGlo Pro Push-Button & Glow Indicator LED D.I.Y. Kit" />