|
|
Push rod Seals for wet applications. Requires approximately 3/8-7/16" ID hole in hull or radio box for proper installation. OD of part is .51" x 1.2" Long. SKU Number: TRA1577
|
|
|
|
|
Pushrod exit, works with many nylon type pushrod sleeves. Sand end of sleeve and glue into exit. Glue exit to outer fuse surface for a clean "finished" look. SKU Number: DUB502
|
|
|
|
|
A versatile guide/support for control linkages, throttle, etc. Three holes make it easy to accommodate different set-ups. The Micro Pushrod Guide can be used on foam, wood, etc. For foam, just press pins through and cement with CA or epoxy and cut off any protruding pins. If used on balsa, pre-drill small holes. The guide holes are 0.080O diameter SKU Number: DUB923
|
|
|