This material is what you often see on the ends of square type battery packs. Can also be used to make insulators between cells and other insulating parts. This Thick tough stock has a super sticky adhesive on one side. Is difficult to remove once stuck. Make your own pro looking packs and repairs. Wire end has center hole, blank end of battery pack does not. Price is per piece.
High temperature tape. Use between cells to protect from contact in the event the cells PVC shrink covering may become damaged from heat. Use under balance and output wires to prevent them from contacting cell ends in the event wire insulation melts. Use of this material as an insulator greatly reduces the chance of catastrophic failure from momentary shorts of a battery or extreme use. Good to 572F (300c). 3/8" wide by 36 yards long.
This is the End cap for the wire end of a double stick Sub C type pack. Common on RC car packs or anywhere you need some extra protection on the ends of the cells. Slips over cells before you shrink the pack.
This material is what you often see on the ends of battery packs. Can also be used to make insulators between cells and other insulating parts. Make your own pro looking packs and repairs. 1 piece, AA diameter with center through hole. Price is per piece.
This is the end cap for building your own battery packs. Gives strength and protection to your battery packs. Use with shrink wrap listed below. This size for use on AU size batteries. Choose end or both below at checkout.
This is the end cap for building packs. Common on RC car packs due to rough use, gives some protection. This item is the back end cap for double stick battery configuration. Or end pack opposite the wire output side of the pack.
This material is what you often see on the ends of square type battery packs. Can also be used to make insulators between cells and other insulating parts. This thick durable card stock has a super sticky adhesive on one side that is difficult to remove once stuck. Make your own pro looking packs and repairs. 6" X 4-1/2" Card cuts easily with exacto knife or scissors. Shown is one sample use of paper on square pack resting on top of one card of fish paper. Select thickness(.010, .015, .020, .030") of cards below. Standard thickness is .015-.020".
Price per piece, same for all thicknesses.
SKU Number: RRCFPC
Battery Insulators, Fish Paper and End Caps
When assembling or repacking cells into a battery pack, insulators and end caps guard against shorts between cells and protect the wrapper from damage. This category collects the fish paper, tape, and caps used in that kind of pack building and repair.
Fish Paper Insulators
Fish paper insulators are cut to fit around specific cell arrangements, including the Fish Paper Single AA Insulator, the 4AA Square Pack Insulator, and the Fish Paper Single Sub C Insulator. Placing one between cells or under a wrap helps keep bare metal from touching where it should not, which is easy to overlook on a tightly packed assembly.
Caps and Tape
End caps such as the Sub C Double Stick Wire End Cap and the AU Size End Caps for single stick packs seat over cell ends, and Kapton Tape provides a heat-tolerant way to hold parts of a pack together during and after soldering.
Select the insulators and caps for your pack in the list below.
 "Fish Paper 4AA Square Pack Insulator")
 "Kapton Tape")
 "Sub C Double Stick Wire End Cap")
 "Fish Paper Single AA Insulator")
 "AU Size End Caps for Double Stick Packs")
 "Sub C End Double Stick End Cap Bottom")
 "Fish Paper 6\" x 4-1/2\" Card")
