Use between battery and charger balance board to extend connections. In that sense, these are charge cords for balance purposes. Can also be installed in the model as part of the pack to make the balance harness easier to reach.
Connects 6S packs to balancer and charger using Radical RC connectors. Note: Can be cut in half to make your own pigtails.
SKU Number: RRC6SBAL12EXTTP
Balance Lead Extensions for LiPo Packs
When a battery sits deep in a fuselage or far from the charger, a balance lead extension bridges the gap so you can reach the pack's balance port without straining the wiring. This category offers XH-style balance extensions in the cell counts and lengths most builders reach for.
Cell Counts and Lengths
Extensions are available for 2S, 3S, and 4S packs, matching the balance plug pin count to your battery. Lengths run from a short six-inch lead up to twenty-four inches for reaching batteries mounted well back in the airframe.
2S extensions in 6, 12, and 24 inch lengths
3S extensions in a 12 inch length
4S extensions in a 12 inch length
All of these use the common XH balance plug found on most modern LiPo packs, so they extend rather than adapt the connector. A longer lead also makes it easier to route the balance wire to a charger sitting on the bench.
Pick the cell count and length that fits your setup below.