$7 Minimum Shipping — USA Addresses $13 minimum on phone orders · Worldwide shipping — see checkout for all options · insurance automatically added to USA orders over $50
Slightly smaller than 1/4", it readily fits into a 1/4" snuffer tube. It is easier to light, glows very hot and absolutely will not go out. Calibrated in one-minute marks, it saves builders a lot of lost airplanes. 5 foot length. Do not order, defective wick issue. Hidden from website.
Sport Rubber. Looks like it's in good condition. It is 3/16" wide, 1/32" thick. Sold by the foot. Order quantity by the foot.
Sorry, temporarily out of stock
SKU Number: RRCFFRUB316
Free Flight Model Supplies
Free flight models fly without radio control, relying on careful trim and a rubber or gliding power source, and this category gathers the small parts that keep those models turning props and holding thrust settings. Builders of rubber-powered and lightweight models will find the basics here.
Free Flight Props
Sig free flight props come in 5 inch, 5-1/2 inch, and 7 inch sizes, offered in six packs so you have spares on hand. Some are listed with a nose piece for a ready mount and others as the prop only, letting you match them to your own nose block or bearing setup.
Bearings and Washers
Beads for propeller bearings and brass thrust washers reduce friction at the prop shaft, a small detail that matters on a model powered by stored rubber energy.
Look through the props, beads, and washers above to stock your free flight bench.
 "Beads for Propeller Bearings")
 "Sig 5 Inch Free Flight Prop 6 Pack")
 "Sig 5-1\2 Inch Free Flight Prop W/Nose Piece, 6-Pack")
 "Sig 7 Inch Free Flight Prop Only (no nose piece) 6 Pack")
 "SIG 7 Inch Free Flight Prop w/Nose Piece 6-Pack")
 "Brass Thrust Washers")
 "Sig Sure-Fire D-T")
 "Sig Rubber Power Plastic Wheels")
 "Sig 6:1 Rubber Winder")
 "Sig 16:1 Rubber Winder")
 "HERR 9 1/2 Inch Propeller")
 "Rubber 3/16x1/32 by the Foot")