Push rod Seals for wet applications. Requires approximately 3/8-7/16" ID hole in hull or radio box for proper installation. OD of part is .51" x 1.2" Long.
Pushrod exit, works with many nylon type pushrod sleeves. Sand end of sleeve and glue into exit. Glue exit to outer fuse surface for a clean "finished" look.
A versatile guide/support for control linkages, throttle, etc. Three holes make it easy to accommodate different set-ups. The Micro Pushrod Guide can be used on foam, wood, etc. For foam, just press pins through and cement with CA or epoxy and cut off any protruding pins. If used on balsa, pre-drill small holes. The guide holes are 0.080O diameter
SKU Number: DUB923
RC Pushrod Exits and Seals
A pushrod exit gives a control rod a clean, guided path where it leaves the fuselage on its way to a control horn. Fitting one tidies up an exit slot and helps keep the rod running smoothly to the surface it drives, instead of sawing at the covering or the wood around a bare slot.
Exit Guides
This category includes the Du-Bro Pushrod Exits in Standard and Large sizes, the Lazer Rod Pushrod Exit, and a Hooded Pushrod Exit in Standard size that shrouds the opening for a neater appearance. Mounting an exit usually means gluing it into the slot so the rod is supported and less likely to bind against the airframe.
Seals
On models where keeping debris or exhaust residue out of the airframe matters, the Du-Bro Pushrod Seals and Traxxas Pushrod Seals close the gap around the rod while still letting it move freely, which helps keep the inside of a fuselage cleaner.
Pick the exit or seal that suits your fuselage below.
 "Traxxas Pushrod Seals")
 "Lazer Rod Pushrod Exit"){kind=small}
 "Du-Bro Micro Pushrod Guide (QTY/PKG: 4 )")
