- RC Shop >
- Hardware >
Pushrods
|
| Rod Stock Policy: In order to include long skinny products at our very favorable shipping rates: All USA orders that contain rod-stock items need to contain at least 6 rods. Rod stock is anything over 30". This would include Music Wire, Carbon Rods of any kind, larger Pushrod kits, brass or aluminum rods and anything else of that nature. Thinner items like carbon strips .5mm thick, sub 1mm diameter carbon rods and music wire .020 or thinner ordered in quantities less than 6 rods total will be shipped coiled. Unless otherwise stated, all carbon rod stock is pull-truded construction grade. The resin is heat cured as the fibers are pulled through a die of the proper shape. Sizes are approximate usually within 5%.
All pushrods are found here. Select by size sub category below or in left column under "Pushrods".
|
|
RC Airplane PushrodsPushrods carry the motion from a servo to a control surface, and a clean, low-slop linkage is one of the details that separates a precise-flying model from a sloppy one. This category covers the pushrods and related linkage parts used to connect the radio gear to the ailerons, elevator, rudder, and throttle on a model aircraft. Choosing a PushrodThe right pushrod depends on the length of the run, the loads the surface sees, and how much flex you can accept. Shorter, stiffer rods suit high-load surfaces, while longer runs often use a supported rod to prevent bowing under pressure. Matching the thread and clevis at each end to the rest of your hardware keeps the setup consistent. A well-fitted pushrod removes free play at the horn, which helps the model return to neutral and hold its trim in flight. Review the options below to find a pushrod suited to your linkage. |
