Himax 6.0mm Solid Driveshaft with one collar and two set screws and cir-clip. For HC5030 motors. Smooth shaft with n ground flats. 85mm long. Useful for repairing many other brand motors as well.
Replacement rear (bolt on) prop adapter for 6320 and 6330 series Himax Outrunners. Includes new fasteners to mount to Himax motor, washers and 12mm nut. For those wishing to check other brand motors for possible fit, adapter is setup for 4 each 3mm fasteners in 8mm diameter circle, fits over boss .982" (24.9mm) diameter and adaper base is recessed .132" (3.35mm) to accept boss. Shaft length is 1.45" (36.7mm) long with a diameter of 12mm.
Replacement front prop adapter for 6320 and 6330 series Himax Outrunners. Unit is secured with 2 large set screws and would be useful on any motor with an 12mm shaft. Includes washer and 12mm nut. 1.65" (42mm), base diameter 1.18" (29,88mm), prop shaft length 1.325" (33.65mm), depth of bore for motor shaft .987" (25mm).
SKU Number: HC63-7
Himax Motor Parts
Keeping a brushless outrunner spinning often comes down to a few small components, and this category gathers Himax motor parts for the HC series of outrunners. Whether a shaft is bent after a hard landing or you are stocking spares for the workbench, the pieces here match specific Himax motor sizes.
Replacement Shafts
Solid and hollow replacement shafts are offered in 2.0mm, 3.2mm, and 4.0mm diameters, sized for motor families such as the HC2208, HC2212, and HC2808 series. A hollow shaft option is listed for the HC2808 as well. Matching the shaft to the correct motor series matters, since diameter and length vary across the range and the wrong part will not seat properly.
Complete Motors
The category also includes a radial mount HC50XX series outrunner for builders adding power to a new airframe rather than repairing an existing motor, so both repair parts and a ready motor sit alongside each other here.
Check each listing for the motor series it fits before ordering a replacement part.
 "Himax 6320 & 6330 Rear Mouting (bolt on) Prop Adapter")
 "6320 & 6330 Front Mounting (slip over) Prop Adapter")
