Use this cable and software to connect your Pocketlader and Microlader charger to your Windows PC through the USB or Serial interface. With the included MicroLog software, It allows you to record and evaluate battery data. An ideal tool for battery diagnostics and maintenance. Also allows control of Charger by Orbit Lipo Check Pro when balancing your valuable Lipo packs. This software and cable is also required to get free firmware/flash updates for your charger.

Included items: SIO-PC ISB interface harness with DB9, MICROLOG software (Windows 95 or later).

Sorry, out of stock, discontinued by Radical RC.

The LiPoChecker Pro8s is a voltage checker and a balancer / equalizer for LiFP+Lion+LiPo Lithium batteries combined in one device. Eight separate circuits allow the LiPoChecker pro to balance battery packs up to 8s and a maximum charging voltage of 4.23 V per cell. This can be done preferably during charging, but also afterward or during a full test of the battery pack. The LiPoChecker pro universal connector system (16pin header), known from Personal Computers, is easily available and allows an easy adaptation to common connector systems, such as Graupner, robbe, Thunderpower, Tanic, Polyquest etc. Ready-to-use adapters are available from Orbit electronic. An additional SIO feedback line allows voltage data of the individual cells to be sent to the evoJet Orbit POCKETLADER or MICROLADER battery chargers. That way, alarm states can be easily detected (closed loop) and the charging result can be optimized even with old or low-grade battery packs.

Connection: 16 pin male header
Operating voltage: +2.1V to +4.5V
Diversion: max.1000mA
Balancing: 3.4V - 4.23V
Dimensions: 41 x 16 x 160 mm / 1.6" x 0.6" x 6.3"

SOLD OUT 

This is the adapter you'll need for Graupner/Robbe Lipo battery packs to the Balancer/Checker.
SKU Number: EVO0685G

This is the adapter you'll need for custom Lipo battery packs with BEC connectors to the Balancer/Checker.
SKU Number: EVO0685B

Photo shows three plugs for configuration only. Priced per one plug.

Sorry, sold out, no longer available 

Microlader 6.1-6.4: => update by new chip 6.5
Microlader PRO 6.1-6.4: => update by new chip PRO6.5
Microlader RACE 61/62: => update by new chip, but RACE 63 only!

Once again smart evoJet Orbit owners get to update their chargers to the latest cell technology. It's cheaper in the long run to own the best! Don't be a tightwad on your next charger, get an evoJet Orbit and in the end you'll spend less than all the rest. Some of my customers are on their 5th upgrade now. Every upgrade is a time they didn't have to buy a new charger to keep pace with technology. Hmmm, lets see, that amortizes their charger down to cost around $60. Proven again; It's cheaper to buy the best if you plan on being alive for a few years. ;-)

Installation: Remove top of charger. Note notch on chip is oriented towards front (operator side) of charger. Carefully extract old chip. Being careful not to touch pins of new chip, press into socket with notch towards front of charger. Work into slot evenly. Replace cover. Power up charger. Installing the chip backwards damages charger requiring return to Germany for repair.

evoJet Orbit 6.0 owners: Early 6.0 chargers have a processor in them that was discontinued, late 6.0 chargers are the same as modern Orbit units. If you can toggle the language between English and German in setup then your charger is a later charger and can be chip updated. We suggest you send the unit in for calibration and update at this age. Early 6.0 chargers and Pre-6.0 chargers may be updated with a new board or receive a one time only update by round trip to Germany.

DISCONTINUED BY EVOJET ORBIT, LUXURY TYPE SOLD OUT, SORRY, WHILE SUPPLIES LAST!

This is the adapter you'll need for Thunder Power & Flight Power / Radical RC / E-sky / E-Flight / Most China Lipo battery packs to the Balancer/Checker.

SKU Number: EVO0685T3S

This is the adapter you'll need for Thunder Power, Flight Power, Radical RC, E-Sky, E-Flight and most China Lipo battery packs to the Balancer/Checker.

SKU Number: EVO0685T4S

This is the adapter you'll need for Thunder Power & Flight Power / Radical RC / E-sky / E-Flight / Most China Lipo battery packs to the Balancer/Checker.

SKU Number: EVO0685T5S