RC Clevis Rod Ends for 1mm Wire

RC Clevis Rod Ends for 1mm Wire

The connection between a pushrod and a control horn has to be secure yet easy to adjust, and small rod-end fittings handle that job on light models. This category covers rod ends and retainers sized for 1mm, or .039 inch, wire, a common gauge on park flyers and smaller sport airplanes.

L Bend Retainers

Radical RC carries GWS L bend retainers for .039 inch wire. An L bend retainer slips over the bent end of a wire pushrod where it passes through a control horn, holding the wire in place so it cannot work its way out during flying.

Fittings this size keep the linkage light, which matters on small models where added tail weight affects trim and balance. They install quickly and can be removed if you need to re-adjust a control throw.

See the fitting details below to confirm it matches your wire size.