36" (0.914M) ANTENNA HOUSING Handy plastic tube. Great way to get a plastic tube for custom push-rod or bearing purposes. Normally used to safely route an aircraft frequency antenna through a fuse. Use this also to route music wire push-rod, cable or any other creative purpose you have in mind.
Just like 12" sections above except longer and natural semi-transparent clear/white color. Tube only, no cap or other hardware with this item. Photo shows a quantity of tubes. This item is shipped as 1 tube. We don't make you buy the whole package of 18. A single plastic tube from a Dubro 511 package will be shipped per item ordered.
Rod Stock Policy does not apply to this item because it can be shipped rolled. If ordered with other rod stock items (minimum 6 pieces of long rod like items) it will be shipped straight.
Works great for airplanes, cars, boats, and helicopters.
Priced per piece, sold 24/tube increments only.
Dimensions: 0.074" (1.88 mm) ID .134" (3.4 mm) OD
Made in USA
SKU Number: DUB511
1.7mm Pushrods for RC Aircraft
Pushrods carry servo movement to the control surfaces of a model, and this category covers 1.7mm (.067 inch) diameter pushrods along with a related guide tube. The narrow diameter suits smaller and lighter airframes where a thinner rod keeps weight down while still handling light control loads.
Threaded Pushrods
The Radical RC 1.7mm pushrod comes threaded on one end, which lets you add a clevis or keeper for an adjustable connection at the control horn while the plain end is secured at the servo. Threading one end this way is a common approach for setting up and fine-tuning throws.
Guide Tubing
A 36 inch antenna housing tube is also listed here; builders often use lengths of light tube like this to guide and support a thin pushrod through the fuselage, reducing flex over longer runs.
See the items below to match a 1.7mm pushrod and tubing to your setup.
 "RRC 1.7 mm Pushrod Threaded One End")
 "Antenna Housing Tube 36 Inch")
